
Home WTR HUB
-
The Generosity™ Home WTR HUB produces high quality alkaline water with a pH balance of 10.0. This unit takes your local water source and removes all dangerous impurities and add our Active Alkaline Technology. While most alkaline water products use inactive ingredients that lose their pH level over time, Generosity Water is engineered with natural, active bioavailable minerals that maintain a pH level of 10.0.
Tankless Under The Sink Design
The Generosity™ Home WTR HUB’s compact and sleek filter system with a small and convenient footprint takes up less space and saves storage under kitchen sink! No tank also means no more secondary pollution. Guaranteed to provide ultra-pure, safe and clean water for you and your family.
1200 GPD High Water Flow
The Generosity™ Home WTR HUB can produce 1200 gallons of water per day. Its high capacity can serve the daily water needs of a large family. The water flow is fast and stable, the system can fill a 330ml cup of water in about 5 seconds.
1.5:1 Low Drain Ratio
Thanks to advanced water-saving technology, this system maximizes the efficiency and can save your water up to 450% compared with conventional RO filter systems on market! Being both economic and environmental friendly, it makes your water bills more affordable. Over the life of the system, The Generosity™ Home WTR HUB pays for itself in water savings!
Intelligent LED Display & Quick Change
The intelligent display panel clearly tells real-time out TDS and remaining lifespan of each filter. The built-in TDS system constantly monitors the quality of your drinking water 24/7. Acting as an intelligent reminder, the color-coded indicators will always remind you to change filters in advance. With all parts included and well-organized instructions and videos, The Generosity™ Home WTR HUB’s filter can be completely installed in a few minutes by yourself.
-
Model No.
HWH 1200
Filter Cartridge Inside
HWH100, HWH101-1200G, HWH102
Additional Filter Cartridge
Alkaline WTR FLTR
Product Dimensions
20.8 x 9.25 x 19.29 inches
Item Weight
33.06 lbs
Working Pressure
Min. 20psi, Max. 80psi
Flow Rate
0.83 GPM
Rated Voltage
110-240 VAC
Frequency
50-60Hz
Rated Power
150 Watts
Operating Temperature
Min. 39°F, Max. 100°F
-
Q: Why there are a lot of white bubbles in the water?
A: Normally for the first time use of the system, the water seems to have white bubbles in it, which is normal and totally drinkable. It is because when the pump is pressurizing the water, it will pressurize the air at the same time. It will make the air molecules smaller, thus the solubility further increases. The air can’t be released at that time because of the pressure in the system. However, when you turn on the tap to get a cup of water, the pressure of air is released. So you will see a huge number of bubbles in the water. It looks cloudy and white, but they are just bubbles. After you put the water still for a while, all bubbles will be gone, and the water is totally good for drinking.
Q: Why TDS is higher at the beginning, but back to normal range after about one minute?
A: Osmosis is a natural phenomenon happens in all RO system, no matter if you have a conventional RO system or tankless RO system. When the RO system starts to work, pressure from the pump overcomes natural osmotic pressure, forcing feed water through the RO membrane that removes the impurities. When the RO system stops working, the pump stops offering pressure as well. At that time, because of different concentrations, a small fraction of ions will enter into pure water and cause TDS to rise by a small amount. However, even if the TDS reading is a little high at the beginning, the quality water is still unbeatable by any other filtration methods including carbon, KDF, ceramic, UF, UV, etc.. The water is totally good to drink and you don’t have to wait for about 1 minute to get the water, since the whole system will not release any harmful substances to the water. The TDS removing rate for PD600-TAM3 is about 94-95%, if your incoming TDS is high, the outlet TDS will be high too.
Q: How does the TDS display on the machine work?
A: When the system is running, the TDS sensor in the PD600-TAM3 will keep testing the water quality every 1 minute. Therefore, the TDS result you see from the machine is from the last test memory. If you want to have the real-time TDS result, please let the machine run for about 1 minute.
Q: If I don’t want to use the TAM3, how should I disconnect it?
A: You don’t have to disconnect the tubing and the fittings on the TAM3. You only need to unscrew the TAM3 filter and the water still can go through.
G-Fountain
-
The G-Fountain allows establishments to provide Generosity’s Alkaline Technology from any water source. Creating an on-demand refillable hydration infrastructure. Generosity™ provides a network of hydration solutions for groups of any size. The G-Fountain delivers sustainability and premium water in one turn key solution. Eliminating the need for millions of plastic bottles, reducing the carbon footprint from production to consumption.
-
Events, Festivals, Stadiums, Arenas, Governmental Park & Recreation, Corporate Campus, Airports & University Campus.
G-Fountain Hydration Station
-
The G-Fountain allows establishments to provide Generosity’s Alkaline Technology from any water source. Creating an on-demand refillable hydration infrastructure. Generosity™ provides a network of hydration solutions for groups of any size. The G-Fountain delivers sustainability and premium water in one turn key solution. Eliminating the need for millions of plastic bottles, reducing the carbon footprint from production to consumption.
-
Events, Festivals, Stadiums, Arenas, Governmental Park & Recreation, Corporate Campus, Airports & University Campus.
